projects:emb_linux_starterkit_wifi
This is an old revision of the document!
Setting up wireless LAN in Sitara starter kit
Sitara starter kit is a great tool for embedded Linux development. I do not want to use Ethernet cable and I have no spare keyboard to use therefore I needed to configure connection manually.
By default device have enabled tty0 console at serial line connected to on-board USB hub. When board is connected to PC it should see new virtual COM port. The only user on the device is root without password. I am using unmodified stock firmware.
- Connect board to PC using USB cable. Power the board.
- Connect to board using PuTTY (Serial 11500) COM port number depends on user system.
- Start re-boot board
- Login as root
- Create psk hex using wpa_passphrase and put it in
/etc/wpasupplicant.conf
(wpa_passphrase network_ssid password >> /etc/wpasupplicant.conf
). - Edit
- Reset network interface
/etc/init.d/networking reset
projects/emb_linux_starterkit_wifi.1375039360.txt.gz · Last modified: 2013/07/28 21:22 by mkucia